RS ELECTRONICS

DISTANCE CALCULATION FOR UNDERGROUND CABLE FAULT


PROJECT DESCRIPTION

The objective of this project is to determine the distance of underground cable fault from base station in kilometres. The underground cable system is a common practice followed in many urban areas. While a fault occurs for some reason, at that time the repairing process related to that particular cable is difficult due to not knowing the exact location of the cable fault. The proposed system is to find the exact location of the fault.

The project uses the standard concept of Ohms law i.e., when a low DC voltage is applied at the feeder end through a series resistor (Cable lines), then current would vary depending upon the location of fault in the cable. In case there is a short circuit (Line to Ground), the voltage across series resistors changes accordingly, which is then fed to an ADC to develop precise digital data which the programmed microcontroller of 8051 family would display in kilometres.

The project is assembled with a set of resistors representing cable length in KM’s and fault creation is made by a set of switches at every known KM to cross check the accuracy of the same. The fault occurring at a particular distance and the respective phase is displayed on a LCD interfaced to the microcontroller.


BLOCK DIAGRAM

FIG: DISTANCE CALCULATION FOR UNDERGROUND CABLE FAULT

HARDWARE REQUIREMENTS

  • 8051 series Microcontroller
  • LCD
  • Crystal
  • ADC
  • Relays
  • Relay Driver IC
  • Transformer
  • Diodes
  • Voltage Regulator
  • Resistors
  • Capacitors
  • LEDs
  • slide switches


SOFTWARE REQUIREMENTS

  • Keil Compiler
  • Language: Embedded C or Assembly